水产品及养殖水中丁香酚类化合物风险研究

目的 检测水产品及养殖水中丁香酚类化合物。方法 应用食品补充检验方法BJS 201908《水产品及水中丁香酚类化合物的测定》，以海水鱼、淡水鱼、海水虾、淡水虾及养殖水作为基质，测定6种丁香酚类化合物的含量。结果 通过对实际样品测定后发现，在水产品中检出了丁香酚类化合物，主要为丁香酚，检出率为28.9%，其中海水鱼相对突出。结论 本研究为丁香酚作为渔用麻醉剂提供了方法论，为丁香酚类化合物在水产运输的合理使用提供理论依据。     

Invited review: Freedom from thirst—Do dairy cows and calves have sufficient access to drinking water?

The importance of drinking water for production and animal welfare is widely recognized, but surveys and animal welfare assessment schemes suggest that many dairy calves and dairy cows do not have sufficient access. Limit milk-fed calves drink more water than calves fed milk ad libitum, but ad libitum milk-fed calves also require access to drinking water, as milk does not meet the animal's requirement for water. At hot ambient temperatures and when calves are sick, access to water is especially important and should be provided at all times. Many young calves do not have access to water throughout 24 h, and whether healthy young calves require free access to water at all times, or from which age, is not clear and requires further study. Dairy cow free water intake (FWI) is largely determined by milk yield, and high-yielding dairy cows may drink up 100 L of water per day. Dry matter, crude protein, and salt content of feed, as well as ambient temperature, have considerable effects on dairy cow water intake. Deprivation of water affects meal patterning for the cow, as well as increased subsequent rate of drinking and compensatory water intake. Although dairy cow ad libitum water intake may exceed the water provision necessary to maintain production, offering water for ad libitum intake may be necessary to safe guard animal welfare. Cattle are suction drinkers that prefer to drink from large open water surfaces, and Holstein dairy cows can drink at a rate of up to 24 L/min. Research on the effect of design and placement of water troughs for indoor-housed dairy cows on their drinking behavior and water intake is limited. Access to a water source at pasture increases the time cows spend there, and access to shade reduces water requirements during periods of warm weather. In both indoor and pastured cattle, there is a lack of knowledge about the effect of stocking of water troughs on competition, drinking behavior, and intake in dairy cows. Studies on the effect of available water trough length and placement, and of the number of cows being able to drink from the same trough of a given dimension, are needed to evaluate current recommendations.     

现代市政道路给排水管道工程的设计与施工探讨

市政道路给排水管道工程设计与施工是一个综合性的过程,要考虑各个方面的影响因素,其工程质量关系着城市运行的稳定性,具有非同寻常的作用。在市政道路给排水工程施工中,需要涉及到多个工艺环节,要合理调控各个环节的连接关系,保证工程的有序施工,严格管控工程质量。     

Heterogeneous Bimetallic Mo-NiPx/NiSy as a Highly Efficient Electrocatalyst for Robust Overall Water Splitting

Highly efficient electrocatalysts composed of earth-abundant elements are desired for water-splitting to produce clean and renewable chemical fuel. Herein, a heteroatomic-doped multi-phase Mo-doped nickel phosphide/nickel sulfide (Mo-NiP_x/NiS_y) nanowire electrocatalyst is designed by a successive phosphorization and sulfuration method for boosting overall water splitting (both oxygen and hydrogen evolution reactions (HER)) in alkaline solution. As expected, the Mo-NiP_x/NiS_y electrode possesses low overpotentials both at low and high current densities in HER, while the Mo-NiP_x/NiS_y heterostructure exhibits high active performance with ultra-low overpotentials of 137, 182, and 250 mV at the current density of 10, 100, and 400 mA cm⁻² in 1 m KOH solution, respectively, in oxygen evolution reaction. In particular, the as-prepared Mo-NiP_x/NiS_y electrodes exhibit remarkable full water splitting performance at both low and high current densities of 10, 100, and 400 mA cm⁻² with 1.42, 1.70, and 2.36 V, respectively, which is comparable to commercial electrolysis.     

循环水替代7℃水在氯乙烯精馏装置中的应用研究

详细计算了PVC生产精馏系统换热设备的热负荷、循环水量及运行成本,认为通过调整系统的运行温度和压力,精馏装置使用循环水替代7℃水具有可行性,这将有利于突破能耗高的技术瓶颈,最大程度地发挥节能降耗、减污增效的潜能。     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

Catalytic supercritical water oxidation of tri-n-butyl phosphate: Process optimization by response surface methodology and cytotoxicity assessment

Catalytic supercritical water oxidation (SCWO) of an organophosphate flame retardant, namely tri-n-butyl phosphate (TNBP) was studied. Firstly, copper oxide nanoparticles (NPs) were synthesized in SCW and their properties were characterized by various analyses. Afterwards, their catalytic performance was investigated under different conditions including reaction temperature (400–500 °C), TNBP volume percentage in the feed (1–4%), oxidant ratio (0–2) and reaction time (50–150 min) based on response surface methodology (RSM). The synthesized CuO NPs had an average particle size of 30 nm with a narrow distribution. According to RSM analysis, the reaction temperature and time are the most significant factors; whereas, the impact of the other factors, especially TNBP volume percentage in the feed, was found to be negligible. Overall, excellent performance was achieved under optimal conditions found by the RSM, which was reaction temperature of 500 °C, TNBP volume percentage of 4%, oxidant ratio of 1.5, and reaction time of 90 min. The TOC removal efficiency as an indicator of TNBP degradation was about 99%. Finally, in vitro cell viability assays for the cytotoxicity evaluation of fresh and SCW-treated solution were applied. The results of MTT showed that SCWO converts TNBP into by-product that did not induce any cytotoxicity.     

Montmorillonite-perlite-iron ceramic membranes for the adsorption/removal of As(III) and other constituents from surface water

In this study, ceramic membranes made of montmorillonite, perlite and iron were used to remove As(III) from water. Membranes prepared with 0.0, 0.5, 1.0, and 1.5 wt% of iron content were used to filtrate As(III) synthetic water and surface water solutions. As(III) adsorption capacity and removal efficiency, and other parameters such as cations and anions content, turbidity, pH, electrical conductivity were used to evaluate the membranes' performance. Results show that the As(III) adsorption/removal capacity of membranes was improved by the addition of iron. Adsorption capacity of 7.5 μg As(III)/g and removal efficiency of 97% can be achieved in membranes with 1.0 wt% of iron filings content for surface water; however, a greater amount of iron in the membrane structure limits the adsorption capacity of As(III). Besides the capacity of ceramic membranes to adsorb/remove As(III), membranes were also effective to remove other ions, turbidity, and electrical conductivity from the surface water. The addition of iron to the ceramic membranes enhanced their capacity to remove such surface water constituents. These results are important from the practical viewpoint showing the potential of ceramic membranes for the removal of metalloids and other water constituents. Langmuir isotherm model best described the adsorption process in ceramic membranes, suggesting that adsorption of As(III) happened on a monolayered surface of the ceramic membrane.     

重水浓度与吸光度关系曲线类型研究

重水作为反应堆的慢化材料，其浓度直接影响反应堆的安全和性能。为研究其重水浓度与吸光度间的关系曲线类型，基于朗伯-比尔定律，从理论上推导出液态重水中某种水分子的红外吸收峰分别与0~2种其他水分子的红外吸收峰发生重叠时重水浓度与吸光度间的关系式，分情况对二者之间的关系曲线类型进行讨论。采用傅里叶变换红外光谱仪，测得浓度为0.015%~99.98%（摩尔比）的重水标准样品吸收光谱，对重水浓度和吸光度间的关系曲线类型进行验证，理论推导与实际吻合。研究表明，一般情况下，宽浓度范围内，重水浓度与吸光度间的关系曲线类型为二次曲线；窄浓度范围内，关系曲线类型为线性。特殊情况下，吸光度为定值或关系曲线类型为线性。